RJW Series of Rolling Jacks 27 P/N 5900093 — Rev. B — October 2020
Disposing of Hydraulic Fluid
Used Hydraulic Fluid cannot be thrown in the regular trash or dumped into the environment. This
pollutes the environment and is illegal.
Instead, take it to a recycling center. Used/dirty Hydraulic Fluid can be cleaned and re-used.
Important: If your Hydraulic Fluid is
contaminated
(by being mixed with other fluids such as
antifreeze, gasoline, or solvents), you must treat it like a hazardous waste and take it for
disposal at an appropriate facility. Contaminated is different than used/dirty.
In summary:
• If you have dirty/used Hydraulic Fluid, take it to a fluid recycling center.
• If you have contaminated Hydraulic Fluid, take it to a hazardous waste collection facility.
If you do not know how to find an appropriate facility, go to earth911.com or look for resources in
your state or local area.
Troubleshooting
This section describes how to troubleshoot your Jack.
Issue Action to Take
Jack does not lift load. Make sure load is not too heavy.
Make sure Rolling Jack is getting appropriate air pressure from the air
supply.
Make sure the Air-Operated Hydraulic Pump has sufficient Hydraulic
Fluid and the hose is connected to the Rolling Jack.
Make sure dirt has not gotten into the hydraulic system. If it has,
replace the Hydraulic Fluid and clean the hydraulic system.
Jack does not move along
Utility Rail.
Make sure the Utility Rail Channels and Lips are clear of obstructions.
Make sure the Rolling Jack is correctly situated on the Utility Rail
Channel or Lip.
Check with BendPak to make sure the Rolling Jack is installed on an
approved Lift.
Jack raises load but does
not stay up.
Make sure you put the Rolling Jack onto a Safety Lock when the load
is at the desired height. The Rolling Jack is meant to raise and lower
loads; it is not designed to hold a load indefinitely unless the load is on
a Safety Lock.
Make sure the Rolling Jack is not leaking Hydraulic Fluid.
If you continue to have issues with your Rolling Jack, take it out of service, then contact your dealer,
go to bendpak.com/support, email support@bendpak.com, or call (800) 253-2363.
To Next Page
Loading...
Need help?
General
