RJW Series of Rolling Jacks 5 P/N 5900093 — Rev. B — October 2020
• Make a thorough inspection of the product at least once a year. Replace any damaged or severely
worn cables, hydraulic hoses, decals, or warning labels. Do not use the product until worn or
damaged items have been replaced.
• Do not touch hot parts; you could be burned.
• Take care locating cables and hoses; you do not want them driven over or stepped on.
• Always wear steel-toed footwear and safety glasses when using the Jack.
• Clear the area immediately if a Vehicle is in danger of falling off the Rolling Jack.
•
Make sure the Rolling Jack is engaged on its Safety Locks before starting work.
• Operating temperature range for a Rolling Jack is 41°F to 104°F (5°C to 40°C).
• Make sure the weight of a Vehicle being raised by a Rolling Jack does
not
exceed its maximum
lifting capacity.
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that
will
result in death or severe injury.
⚠ WARNING Calls attention to a hazard or unsafe practice that
could
result in death or severe
personal injury.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Tip Calls attention to information that can help you use your product better.
Liability Information
BendPak assumes
no
liability for damages resulting from:
• Use of the equipment for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak.
• Injury or death caused by modifying, disabling, overriding, or removing safety features.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.
To Next Page
Loading...
Need help?
General
