3 - 23
Instrument and control functions
EN
3
With the engine turned o:
1. Move the sidestand down.
2. Make sure that the start/engine stop switch is set to “ ”.
3. Turn the key on.
4. Shift the transmission into the neutral position.
5. Press the electric start button.
Does the engine start?
With the engine still running:
6. Move the sidestand up.
7. Keep the clutch lever pulled.
8. Shift the transmission into gear.
9. Move the sidestand down.
Does the engine stall?
After the engine has stalled:
10. Move the sidestand up.
11. Keep the clutch lever pulled.
12. Press the electric start button.
Does the engine start?
The system is OK. The motorcycle can be ridden.
The neutral switch may not be working correctly.
The motorcycle should not be ridden until
checked by a Benelli dealer.
The sidestand switch may not be working correctly.
The motorcycle should not be ridden until
checked by a Benelli dealer.
The clutch switch may not be working correctly.
The motorcycle should not be ridden until
checked by a Benelli dealer.
YES
YES
YES
NO
NO
NO
WARNING
• The vehicle must be placed on the centerstand
during this inspection.
• If a malfunction is noted, have a Benelli dealer
check the system before riding.
To Next Page
Loading...
Need help?
General
