Motorcycle care and storage
EN
7
hidden part of the windshield to
make sure that it does not leave
any marks. If the windshield is
scratched, use a quality plastic po-
lishing compound after washing.
After normal use
Remove dirt with warm water, a mild de-
tergent, and a soft, clean sponge, and then
rinse thoroughly with clean water. Use a
toothbrush or bottlebrush for hard-to-re-
ach areas. Stubborn dirt and insects will
come o more easily if the area is covered
with a wet cloth for a few minutes before
cleaning.
After riding in the rain, near the sea or on
salt-sprayed roads
Since sea salt or salt sprayed on roads
during winter are extremely corrosive in
combination with water, carry out the
following steps after each ride in the rain,
near the sea or on salt-sprayed roads.
NOTE
Salt sprayed on roads in the winter may
remain well into spring.
1. Clean the motorcycle with cold water
and a mild detergent, after the engine has
cooled down.
NOTICE
Do not use warm water since it increa-
ses the corrosive action of the salt
Apply a corrosion protection spray on all
metal, including chrome- and nickel-pla-
ted, surfaces to prevent corrosion.
After cleaning
1. Dry the motorcycle with a chamois or
an absorbing cloth.
2. Immediately dry the drive chain and lu-
bricate it to prevent it from rusting.
3. Use a chrome polish to shine chrome,
aluminum and stainless-steel parts, inclu-
ding the exhaust system. (Even the ther-
mally induced discoloring of stainless-
steel exhaust systems can be removed
through polishing.)
4. To prevent corrosion, it is recommen-
ded to apply a corrosion protection spray
on all metal, including chrome and nickel
plated, surfaces.
5. Use spray oil as a universal cleaner to
remove any remaining dirt.
6. Touch up minor paint damage caused
by stones, etc.
7. Wax all painted surfaces.
8. Let the motorcycle dry completely be-
fore storing or covering it.ì
WARNING
Contaminants on the brakes or tires
can cause loss of control.
• Make sure that there is no oil or
wax on the brakes or tires.
• If necessary, clean the brake discs
and brake linings with a regular
brake disc cleaner or acetone, and
wash the tires with warm water
and a mild detergent. Before ri-
ding at higher speeds, test the
motorcycle’s braking performan-
ce and cornering behavior.
NOTICE
• Apply spray oil and wax sparin-
gly and make sure to wipe o any
excess.
• Never apply oil or wax to any rub-
ber and plastic parts, but treat
them with a suitable care product.
• Avoid using abrasive polishing
compounds as they will wear away
the paint.
7 - 2
To Next Page
Loading...
Need help?
General
