Beninca CALL Manual

If a reply should be sent by the device, the command shall be:
?smsreset 112233
The reply will be: “COMMAND OK”
9) OUTPUT COMMAND MESSAGE:
This command permits to modify the text of channel activation SMS, so as to be able to combine a specic
output to an ID word of the device to be activated or deactivated.
(example: if the gate is connected to channel 1, the SMS linked to channel 1 can be modied with the word-
ing “GATE”)
setcmdmsg 112233 1 GATE
where:
setcmdmsg command string
112233 access password
1 SMS to be modied (1-4)
GATE channel activation string (20 digits max)
N.B.: the text of the 4 SMS is the default text: Ch1, Ch2, Ch3 and Ch4 (words corresponding to SMS1,
SMS2, SMS3, SMS4, respectively)
If a reply should be sent by the device, the command shall be:
?setcmdmsg 112233 1 GATE
The reply will be: “COMMAND MESSAGE SET”
10) ADD TRANSMITTER CODE IN THE RECEIVER CONNECTED TO MODULE:
This command permits to add a transmitter code to the receiver memory without necessarily gain access to
the control unit (the serial number of the transmitter to be entered must be known). Through this command
only 2-channel transmitters can be entered. To enter 4-channel transmitters proceed through the radio
Menu of the receiver (see instructions of RR.4).
addtx 112233 02D762D
where:
addtx command string
112233 access password
02D762D string of 7 hexadecimal digits (0 – F) representing the SN of the TX to be
added to the receiver memory
N.B.: the following is added by default to the TX added : key1>channel, key 2>channel 2.
The serial number of remote controls is indicated outside the remote controls in series, or it can be read
through the ADVANTAGE system.
If a reply should be sent by the device, the command shall be:
?addtx 112233 02D762D
The reply will be: “COMMAND OK”
11) HOW TO DISABLE THE TX PRESENT IN THE RECEIVER CONNECTED TO THE MODULO:
This command permits to disable a transmitter. This will remain stored in the receiver memory but it will not
activate any channel (to restore it, use command “addtx”)
distx 112233 02D762D
where:
distx command string
112233 access password
02D762D string of 7 hexadecimal digits (0 – F) representing the SN of the TX to be
disabled from the receiver memory
N.B.: To reset a disabled transmitter, enter it again with command “addtx”
If a reply should be sent by the device, the command shall be:
?distx 112233 02D762D
The reply will be: “COMMAND OK”
8
9
www.gałecki.pl

Beninca CALL Specifications

General

Brand	Beninca
Model	CALL
Category	Receiver
Language	English