22
LCD DISPLAY
The LCD display can be turned by 180°.
- Cut off mains power supply
- Press OK
- While keeping OK pressed, reset the mains power supply
- Keep OK pressed (around 5 sec) until the software version appears, turned by 180°.
Normally proceed with programming.
DIAGNOSTICS
In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches, control and safety) can be displayed. One
segment of the display is linked to each input. In the event of failure it switches on according to the following scheme.
PHOTO
SWC
STOP
SWO
PHOTC DAS
PHO4PHO3
P.P. PED
OPEN
CLOSE