Beninca LO.R1-2 Series User Manual

• That LED 1 is not flashing in a continuous mode with about two flashes per second: in this case the memory module
is not connected or it is damaged.
Connections
1,2) Relay contact 1 (N.O.)
3,4) Relay contact 2 (N.O.)
5) Power supply 24Vac, negative 24Vdc
6) Power supply 24Vac, positive 24Vdc
9) Antenna mass
10) Tuned antenna signal
A
B
C
D
A
B
C
D
Trasmitter
Fig. 1
Fig. 2
Fig. 3
Power supply
Yellow colour
LO.M3
Learning
key
Led 2
Radio diagnosis
Connector for
memory LO.M3
Memory module
The card memorizes all codes of the
transmitters learned by the receiver on a
non-volatile EEPROM memory (in case of
power failure the codes are not lost).
If the receiver is replaced, but the same
memory is still used, it is not necessary to
store the codes of all transmitters again
in memory.
Before inserting or extracting the memory
card, switch the receiver off!
Radio
Important!
Do not
move the
calibration
keys.
Led 1
self-learning
Dip-switch
function selection
Antenna
Braid
Relay
2
Relay
1
12345678910
Relay 2
Relay 1
Technical specifications
Frequency
Type of receiver
Antenna impedance
Antenna
Power supply
Consumption
Codes available
Range
No. of channels
Relay output
Operating temperature
433.92MHz
Super-reactive
50Ohm
Tuned at 433.92MHz
24Vac/dc, ±20%
50mA max.
18 billion billions
50-150 metres in free space
1 (LO.R1LCV), 2 (LO.R2LCV)
0.5A, 120Vac - 1A, 30Vdc N.A.
(-10 ÷ +55) °C
433.92MHz
With SAW filter and narrow band
50Ohm
Tuned at 433.92MHz
24Vac/dc, ±20%
50mA max.
18 miliardi di miliardi
80-250 metres in free space
1 (LO.R1WCV), 2 (LO.R2WCV)
0.5A, 120Vac - 1A, 30Vdc N.A.
(-10 ÷ +55) °C
40.665MHz
Quartz
50Ohm
Tuned at 40.665MHz
24Vac/dc, ±20%
70mA max.
18 miliardi di miliardi
80-250 metres in free space
1 (LO.R1ECV), 2 (LO.R2ECV)
0.5A, 120Vac - 1A, 30Vdc N.A.
(-10 ÷ +55) °C
LO.R1-2LCV LO.R1-2WCV LO.R1-2ECV
On
Off
1234
a
Ch.1 Ch.2
bab
On
Off
1234

Beninca LO.R1-2 Series Specifications

General

Brand	Beninca
Model	LO.R1-2 Series
Category	Receiver
Language	English