Need help?Do you have a question about the Beninca TO.GO 4A and is the answer not in the manual?
General| Type | Remote Control |
|---|---|
| Channels | 4 |
| Frequency | 433.92 MHz |
| Number of buttons | 4 |
| Type of encoding | Fixed code |
| Operating Voltage | 12V |
| Protection Degree | IP40 |
| Battery Type | 12V (23A) |
Receiver inside controller, terminal board connection. Handles ARC, HCS, fixed codes.
Receiver inserted into controller via molex, powered by controller. Handles ARC, HCS, fixed codes.
Procedure for storing transmitters in ONE.2WB/ONE.2WO receivers using CH1 (RED LED) and CH2 (GREEN LED).
Procedure for storing transmitters in ONE.2WI receivers using CH1 (RED LED) and CH2 (GREEN LED).
Procedure to learn a new transmitter using an existing one in WB/WI receivers.
Procedure to learn a new transmitter using an existing one in control units with built-in receivers.
Process to replicate all channels of an original transmitter to a new AK transmitter.
Process to replicate specific channels of an original transmitter to a new AK transmitter.
To Next Page
