11 How to install the monitor hardware
5. Connect the 12VDC power cable.
Take the 12VDC power adaptor cable and plug the end
into the socket labelled ‘POWER IN’ on the rear of the
monitor. Do not connect the power adapter to a power
point just yet.
6. Fit the (optional) Speaker unit.
If you have the optional Speaker unit, install it now by
following the Speaker Installation Guide.
7. Refit the cable cover.
Replace the cable cover over the cables.
8. Connect-to and turn-on the power.
Plug the power cable into the power adaptor and into a
power point and turn it on.
Picture may differ from product supplied for
your region.
Turn on the monitor by pressing the power button
located at the top of the row of buttons on the right edge
of the monitor.
Turn on the computer too, and follow the instructions in
Getting the most from your BenQ monitor to install
the monitor software.
Monitor showing all cables in place
Monitor showing rear cover in place
To Next Page
Loading...
Need help?
General
