4 Important safety instructions
Important safety instructions
Y our projector is desig ned and tested to meet the latest standards f or saf ety of inf ormation technolog y
equipment. However, to ensure safe use of this product, it is important that you follow the instructions
mentioned in this manual and marked on the product.
1. Please read this manual before you
operate your proj ector. Save it for future
reference.
2. Do not look straight at the proj ector
lens during operation. The intense light
beam may damage your eyes.
3. Refer servicing to qualified service
personnel.
4. Always open the lens shutter (if any) or
remove the lens cap (if any) when the
projector light source is on.
5. The light source becomes extremely hot
during operation. Allow the projector to cool
for approximately 45 minutes prior to
removing the light source assembly for
replacement.
6. In some countries, the line voltage is NOT
stable. This projector is designed to operate
safely within a mains voltage between 100 to
240 volts AC, but could fail if power cuts or
surges of ±10 volts occur. I n areas where
the mai ns vol tage may f luctuate or cut
out, it is recommended that you
connect your projector through a power
stabilizer, surge protector or
uninterruptible power supply (UPS).
7. Do not block the projection lens with any
objects when the projector is under
operation as this could cause the objects to
become heated and def ormed or even cause a
f ire. To temporaril y turn of f the lig ht source,
use the blank function.
8. Do not operate light source beyond the rated
light source life. Excessive operation of light
source beyond the rated life could cause them
to break on rare occasions.
To Next Page
