To Next Page
R
Raven SandersAug 8, 2025
How to turn on BenQ Projector from standby mode?
- SScott CummingsAug 8, 2025
If your BenQ Projector is in standby mode, press the ON key on the remote controller or the Power key on the control panel to power it on.
How to turn on BenQ Projector from standby mode?
If your BenQ Projector is in standby mode, press the ON key on the remote controller or the Power key on the control panel to power it on.
What to do if BenQ LU9715 shows safety switch error?
If your BenQ Projector displays a safety switch error, check whether the top cover is correctly assembled and the lens is properly installed. If the issue continues, please call the local service center.
General| Display Type | DLP |
|---|---|
| Native Resolution | WUXGA (1920 x 1200) |
| Brightness | 8000 ANSI Lumens |
| Light Source | Laser |
| Output Connectors | HDMI, VGA |
| Light Source Life | 20, 000 hours |
| Lens Shift | Vertical: ±60%, Horizontal: ±23% |
| Keystone Correction | Vertical: ±30°, Horizontal: ±30° |
| Connectivity | HDMI, VGA, USB, RS-232 |
| Control Terminals | RS-232, LAN |
| Power Consumption | 0.5W (Standby) |
| Contrast Ratio | 100, 000:1 |
| Speakers | 10W |
General safety warnings and cautions related to electrical hazards.
Critical information regarding laser radiation hazards and precautions.
Manual reading, placement, and handling guidelines.
Prohibited environments and operating conditions.
Guidance on maintenance and repair procedures.
Procedures for attaching and detaching lenses.
Procedures for starting and stopping.
Switching between connected devices.
How to move through menus and select options.
Adjusting image quality: mode, brightness, color.
Adjusting aspect ratio, keystone, 3D, etc.
Language, installation, lens memory, zoom.
Table detailing 3D signal formats.
ASCII commands for projector control.
Understanding status lights.
