BenQ LU960UST - User Manual

Other manuals for BenQ LU960UST

Questions and Answers

P
Pamela NguyenAug 11, 2025
How to fix BenQ LU960UST that does not turn on?
- J
  Jennifer KleinAug 11, 2025
  If your BenQ Projector isn't turning on, it could be due to a couple of things: * There might be no power from the power cable. Make sure the power cord is plugged into the AC inlet on the projector and into a working power outlet. If the outlet has a switch, ensure it's on. * The projector might be attempting to turn on again during the cooling process. Wait until the cooling down process is complete.
L
Lindsay ChaneyAug 17, 2025
What to do if BenQ LU960UST remote control does not work?
- E
  Edward AbbottAug 17, 2025
  If the remote control for your BenQ Projector isn't working, consider these possibilities: 1. The battery might be out of power. Replace it with a new one. 2. There might be an obstacle between the remote control and the projector. Remove any obstacles. 3. You might be too far away from the projector. Ensure you are within 7 meters (23 feet) of the projector.
R
Russell TylerAug 27, 2025
What to do if my BenQ Projector has no picture?
- J
  Jose ShortAug 27, 2025
  If your BenQ Projector displays no picture, there might be a few reasons: * The video source might not be turned on or connected correctly. Ensure the video source is on and the signal cable is properly connected. * The projector might not be correctly connected to the input signal device. Check the connection. * The input signal might not be correctly selected. Use the SOURCE key on the projector or remote control to select the correct input signal.
L
Larry WilsonSep 2, 2025
Why is my BenQ Projector image blurred and how to fix it?
- D
  Daniel MartinezSep 2, 2025
  A blurred image on your BenQ Projector could be caused by: * The projection lens not being correctly focused. Adjust the focus of the lens using the focus ring. * The projector and the screen not being aligned properly. Adjust the projection angle and direction, as well as the height of the unit if necessary.