43 Menu operation
Image Resizing
• Digital Zoom
Magnifies or reduces the projected image size.
1. After the adjustment bar displays, press / on the projector or
ZOOM+/ZOOM- on the remote control repeatedly to reduce or magnify
the image to a desired size.
2. Press OK to enter panning mode.
3. Press the directional arrows ( , , , ) on the projector or remote
control to navigate the picture.
The picture can only be navigated after it is magnified. You can further magnify the picture
while searching for details.
• Digital Shrink & Shift
Shrinks and/or shifts the projected image.
1. After the adjustment bar displays, press / repeatedly to shrink or
magnify the picture to a desired size.
2. Press OK to activate digital shift function.
3. After digital shift function is activated, press the directional arrows ( ,
, , ) to shift the image.
4. Press AUTO to restore the picture to its original size.
The picture can only be shifted after it shrank.
• Blanking
Blanks some parts of the projected image.
1. Select the Modes of Adjustment first by pressing / .
2. Press / to highlight the area you want to adjust and press / to
adjust its range.
Warping
This function aims at correcting the geometric distortion of the projector’s
images when they are projected onto an uneven surface such as a cylinder,
a spherical shape, etc.
• Enable
When this function is enabled, the following functions will not be available:
3D Keystone, Corner Fit, Digital Shrink & Shift, Blanking.
• Warping Pattern
After the warping function is enabled, select a pattern.
To Next Page
Loading...
