BenQ LK935 - Page 49

49 Menu operation
Simulator
Settings
• Simulator Mode
When this function is activated, the following settings will apply:
• Picture Mode will be set as sRGB.
• Direct Power On will be set as On.
• Fast Mode will be activated.
• Standby Mode will be set as Normal.
• IR Receiver
You can enable or disable selected remote receiver.
Factory Default
Returns all settings to the factory preset values.
The following settings will still remain: Projector Position, 3D Keystone, Auto Vertical
Keystone, 12V Trigger, High Altitude Mode, Baud Rate, Corner Fit, Digital Shrink & Shift,
Blanking, Warping, Light Source Information, Security Settings, Network Settings,
Projector ID Setting.
Reset System
Returns all the settings on the System main menu to the factory default
values.
The following settings will still remain: Light Source Information, Security Settings,
Network Settings, Projector ID Setting.