BenQ LW600ST+ - Adjusting Corner Fit

17 Positioning your projector
2. After the 2D Keystone correction page displays. Use / to correct vertical keystone
distortion. Use / to correct horizontal keystone distortion.
Adjusting Corner Fit
You can manually adjust four corners of the image by setting the horizontal and vertical values.
1. Do one of the following steps to display the keystone correction page.
• Press QUICK INSTALL on the remote control. Press to highlight Corner Fit and press
OK.
• Go to Advanced Menu - Display > Corner Fit and press OK.
2. Press / / / to select one corner and press OK.
3. Press / to adjust vertical values.
4. Press / to adjust horizontal values.
Press . Press .
Press . Press .
Corner Fit
Press for 2 seconds to reset
Exit