BenQ LW600ST+ - Page 42

42 Menu operation
System
HDMI
Equalizer
Adjusts the equalizer gain settings for an HDMI signal. The higher the
setting, the stronger the gain value. If there are more than one HDMI port on
the projector, select the HDMI port first before adjusting the value.
USB Power
Switch
Disables or enables "Type A connector" 5V power output. To enable this
function, select On. Select Off when PointWrite Touch Module is not in use to
prevent damage.
Reset Settings
Returns all of the adjustments you’ve made for the Settings menu to the
factory preset values.
Language Sets the language for the On-Screen Display (OSD) menus.
Power
Management
• Eco
When activated, the projector maintains at normal standby mode with less
than 0.5W power consumption.
Changing this setting will make power consumption higher.
• Audio Pass Through: The projector can play sound when it is in standby
mode and the corresponding jacks are correctly connected to devices.
Press / to choose the source that you wish to use. See Connection on
page 18 for how to make the connection.
Background
Settings
• Background: Sets the background for the projector.
• Splash Screen: Allows you to select which logo screen will be displayed
during projector start-up.
Menu Settings
• Menu Type: Switches to the Basic OSD menu. See Using the menus on
page 22.
• Menu Display Time: Sets the length of time the OSD will remain active after
your last key press.
Audio Settings
• Mute: Temporarily turns off the sound.
• Volume: Adjusts the sound level.
• Power On/Off Ring Tone: Turns on or off the ring tone when the projector is
in startup and shutdown process.
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
Factory
Default
Returns all settings to the factory preset values.
The following settings will still remain: Keystone, 2D Keystone, Projector Installation, Light
Usage Time, High Altitude Mode, Security Settings, Baud Rate, HDMI Equalizer, Digital
Shrink & Shift, Digital Lens Shift, Screen Fill.
Reset System
Returns all of the adjustments you’ve made for the System menu to the
factory preset values.