Maintenance 53
5. Pull out the lamp connector from a slot
in the lamp compartment. Disconnect
it from the projector as illustrated.
6. Lift the handle so that it stands up. Use
the handle to slowly pull the lamp out
of the projector.
• Pulling it too quickly may cause the lamp
to break and scatter broken glass in the
projector.
• Do not place the lamp in locations where
water might splash on it, children can
reach it, or near flammable materials.
• Do not insert your hands into the projector
after the lamp is removed. If you touch the
optical components inside, it could cause
color unevenness and distortion of the
projected images.
7. Insert the new lamp into the
lamp compartment and make
sure it fits in the projector.
8. Reconnect the lamp connector
and place it back into its slot to
be flush with the projector.
1
2
2
To Next Page
Loading...
