Troubleshooting32
Status Messages
On-Screen Messages Description
SEARCHING
Projector is searching for input.
ACQUIRING SIGNAL
Projector has identified the input signal and is
running the auto image adjustment function.
OUT OF RANGE
Input signal frequency exceeds the projector’s range.
Lamp Warning - Change
Lamp If Brightness Is Low.
The lamp has been in operation for over 1980 hours.
Install a new lamp for optimal performance. This
message will display for 10 seconds after starting up
the projector.
Out Of Lamp Usage Time -
Change The Lamp! The
Power Will Turn Off After
3000 Hours.
The lamp has been in operation for over 2980 hours,
and the power will turn off after 3000 hours. This
message will display for 30 seconds after starting up
the projector.
Out Of Lamp Usage Time -
Change The Lamp! Press
<MENU> to enable
<RESET>
The lamp has been in operation for over 3000 hours.
The warning message will display for 40 seconds and
then shut down automatically. If you have installed a
new lamp, press <MENU> during the OSD on to
enter for resetting the lamp hour to zero.
To Next Page
