BenQ ST4301K Installation Handbook

71 Troubleshooting
Audio
Remote control
The display flickers when I launch or close a program.
• The signal may not be stable. Check the cable connection or try with another video cable.
• The panel backlight may be unstable. Contact the BenQ authorized service partner for
replacement.
The image is displayed but no sound is heard.
Possible causes Possible solutions
Your graphic card driver is not
installed or updated.
Update the driver through Windows Update (for
Windows Operating Systems) or the graphic card’s
manufacturer.
The audio cable is loose.
Power off the display and re-connect the audio cable.
Power on the display again.
Not external speakers are
connected.
Connect external speakers to the display and adjust the
volume appropriately.
The audio output device is not
consistent with the display setting.
Make sure the setting in Speaker on your display is the
same with the audio output device.
Either the display’s or PC’s
Speaker has been muted.
Disable mute by pressing the MUTE button on the remote
control.
The main board could be
damaged.
Contact the BenQ authorized service partner for
replacement.
(If the signal source is HDMI/DP)
The Speakers in your OS is not
set properly.
Set DisplayPort or HDMI as the default speaker in your
operating system and launch the media player again.
Your display’s audio input is not
set to DisplayPort or HDMI.
Set the Audio Source of your display to DisplayPort or
HDMI.
The remote control does not work.
Possible causes Possible solutions
The remote control does not
work.
Refer to Notes on using the remote control on page 8.
The battery drained out. Replace with a new battery.
The remote control is damaged. Try with a new remote control.
The IR receiver could be damaged.
Check if the LED indicator of the IR receiver lights red or
does not light up. If so, contact the BenQ authorized
service partner for replacement.
It is out of the IR remote control
range.
Check the specifications and adjust the distance between
the remote control and the display.

BenQ ST4301K Specifications

General

Brand	BenQ
Model	ST4301K
Category	Monitor
Language	English