Operation 45
Function Description
Standby
Settings
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER 1 jack is
correctly connected to devices. See "Connection" on page 16 for how
to make the connection.
Audio Pass Through
The projector can play sound when it is in standby mode and the
corresponding jacks are correctly connected to devices. Press / to
choose the source that you wish to use. See "Connection" on page 16
for how to make the connection.
Enabling this function slightly increases the standby power consumption.
Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Phase, H. Size, Projector
Installation, Color Space Conversion, High Altitude Mode, Security
Settings and Baud Rate.
Current
System
Status
Source
Shows the current signal source.
Picture Mode
Shows the selected mode in the PICTURE menu.
Lamp Mode
Shows the current lamp mode.
Resolution
Shows the native resolution of the input signal.
3D Format
Shows the current 3D mode.
Color System
Shows input system format.
Equivalent Lamp
Displays the number of hours the lamp has been used.
Firmware Version
Shows the firmware version of your projector.
To Next Page
Loading...
