8.3 Measures after completed maintenance
After maintenance tasks are complete and before turning the device
back on, complete the following steps:
1. Check any loosened screw connections to be sure they are secure.
2. Ensure that any safety equipment or covers that were removed have
been reinstalled properly.
3. Ensure that all tools, materials, and other equipment used have been
removed from the work area.
4. Clean up the work area, including any materials that leaked out or
dropped, e.g., fluids, processing materials, and the like.
5. Make sure all the safety equipment on the device is functioning prop-
erly.
Operator Manual Surgical Mobile Operating Table Models D860, D850, D 830, D820, D770, D760
Maintenance
95
To Next Page
Loading...
