HYDRONIC UNIT
18
Here is an example of how to connect
the six personalised time periods with
the three intervals for Comfort - home (
), away ( ) and night ( ), unit ON/
OFF setting mode.
Open the flap.
Press the DAYS (
) key under the
thermostat. The numbers 1 to 7 will
flash on the display.
Select one of the options (from 1 to 7,
from 1 to 5, from 6 to 7 or day by day)
by pressing the DAYS (
) key until you
reach the desired option. Select the
option from 1 to 7 if your hourly
schedule for weekdays is the same as
for the weekend.
Once you have selected one of the
options (from 1 to 7, from 1 to 5, from
6 to 7 or day by day 1, 2, 3, 4, 5, 6, 7),
press the PERIOD (
) key under the
thermostat. P1 will flash on the dis-
play.
To change the hours in P1, press the
PERIOD START (
) key at the bottom
of the display. The time 6:00 AM will
flash on the display.
Press the UP or DOWN key until you
reach the desired option.
To change the minutes, press the PE-
RIOD START (
) key at the bottom of
the display. The minutes in 6:00 AM
will flash on the display.
Press the UP and DOWN key until you
reach the desired minutes.
The end time for period 1 (P1) is also
the start time for period 2 (P2). To
change the end time for period 1 –
which also means changing the start
time for period P2 – use the instruc-
tions in the next step to change the
start time for period 2.
1
Press the Touch ‘N’ Go – HOME ( ),
AWAY ( ) or NIGHT ( ) key – you
want to enable during period 1 (P1).
The triangular icon ( ) above the
selected key will flash. This informs
To Next Page
Loading...
