Beretta MYNUTE X C - SETTINGS MENU TREE STRUCTURE; Time Settings; Combination and Configuration Settings; Central Heating Settings

11
ENGLISH
SETTINGS MENU TREE STRUCTURE
Below is a list of the parameters that can be programmed; if the adjustment board does not support the relative function, the interface returns an error message:
The remote control has the function of a machine interface, displaying the system settings and providing access to the parameters.
The display normally shows the temperature of the ow sensor unless there is a domestic hot water request in progress, then the domestic hot water probe temperature is displayed; if no
key is touched within 10 sec the current time is displayed (backlight unlit).
The conguration MENU is organised with a multi-level tree structure. An access level has been xed for each sub-menu: USER level always available; TECHNICAL level password
protected.
Below is a summary of the SETTINGS MENU tree structure.
Some of the information might not be available depending on the access level, the status of the machine or the system conguration.
Menu Parameter Value
Level
password
Value set
in the factory
Personalised
values
SETTINGS
TIME USER
TIME PROGRAMM USER
COMB
GAS TYPE 0 / 1 INSTALLER 0
BOYLER TYPE 1 / 2 / 3 / 4 SERVICE
1 (25 kW)
2 (30 kW)
3 (35 kW)
4 (40 kW)
COMBUSTION OFFSET 0 / 1 / 2 SERVICE
CONF
HYDRAULIC
CONFIGURATION 0 / 1 / 2 / 3 / 4 INSTALLER 1
WATER TRANSDUCER 0 / 1 SERVICE 1
AUTO WATER FILL ENABLE 0 / 1 SERVICE 0
BEGIN SYSTEM FILLING NOT AVAILABLE ON THIS MODEL
AIR PURGING CYCLE 0 / 1 SERVICE 1
MIN INSTALLER
see technical data
table
MAX INSTALLER
see technical data
table
MAX_CH MIN - MAX INSTALLER
see technical data
table
RANGE RATED MIN - MAX_CH INSTALLER
see technical data
table
DO_AUX1 0 / 1 / 2 INSTALLER 0
EXHAUST PROBE RESET 0 / 1 INSTALLER 0
CH
HYST ON HIGH TEMP 2 - 10 SERVICE 5
HYST OFF HIGH TEMP 2 - 10 SERVICE 5
HYST ON LOW TEMP 2 - 10 SERVICE 3
HYST OFF LOW TEMP 2 - 10 SERVICE 3
PUMP CONTROL TYPE 0 - 100 INSTALLER 85
CH POSTCIRC
NOT AVAILABLE ON THIS MODEL
LOW NOISE
NOT AVAILABLE ON THIS MODEL
SCREED HEATING 0 / 1 INSTALLER 0
ANTI CYCLE FUNCTION 0 - 20min INSTALLER 3min
RESET CH TIMERS 0 / 1 INSTALLER 0
MAIN ZONE ACTUATION TYPE 0 / 1 INSTALLER 0
MAIN ZONE ADDR 1 - 6 INSTALLER 3
MAIN ZONE HYDRAULIC CONF 0 / 1 INSTALLER 0
MAIN ZONE TYPE 0 / 1 INSTALLER 0
MAX CH SET
AT: MIN CH SET - 80.5
BT: MIN CH SET - 45.0
INSTALLER
80.5
MIN CH SET
AT: 20 - MAX CH SET
BT: 20 - MAX CH SET
INSTALLER 20
OTR 0 (default) / 1 INSTALLER 0