ServiceandInstallation Manual
Outside cabinet:
Be sure that the unit has access to ample air. Avoid hot corners and locations near stoves and ovens. It is
recommended that the unit be installed no closer than 2" from any wall with at least 12" of clear space above
the unit.
Leveling
A level cabinet looks better and will perform better because the doors will line up with the frames properly.
Use a level to make sure the unit is level from front to back and side to side. Ensure the floor where the
unit is to be located islevel.
Stabilizing
All models are supplied with casters for your convenience, ease of cleaning underneath and for mobility. It
is very important, however, that the cabinet be installed in a stable condition with the front wheels locked
while in use. Should it become necessary to lay the unit on its side or back for any reason, allow at least
24 hours before start-up to allow compressor oil to flow back into place. Failure to meet this requirement
can cause compressor failure and unit damage.
Unit repairs will not be subject to standard unit warranties if due to improper installation
procedures.
Electrical connection
Refer to the amperage data on page 3, the serial tag, your local code or the National Electrical Code to be
sure the unit is connected to the proper power source.
The unit must be turned OFF and disconnected from the power source
whenever performing service, maintenance functions or cleaning the refrigerated
area.
To Next Page
Loading...
