ATTENTION!
• Compare the voltage specification on the type plate with the existing power supply�
• Only connect the cooling unit as follows:
- with the direct current connecting cable to the direct current on-board socket (e�g� cigaret-
te lighter) in the vehicle
- or with the alternating current connection cable to the alternating current mains
• Never pull the plug out of the socket by the connecting cable�
• If the cooling unit is connected to the DC socket: Disconnect your cooling unit and other
loads from the vehicle battery before connecting a quick charger�
• If the cooling unit is connected to the DC socket: Disconnect the connection or switch off
the cooling unit when you switch off the engine� Otherwise the vehicle battery may be
discharged�
• The cooling unit is not suitable for transporting corrosive or solvent-containing materials�
• This cooling unit contains flammable cyclopentane in the insulation� The gases in the insulati-
on material require a special disposal procedure� At the end of its service life, the cooling unit
must be disposed of properly�
SAFETY WHEN COMMISSIONING THE COOLING UNIT
WATCH OUT!
• Ensure that the supply cable and plug are dry before commissioning�
ATTENTION!
• Do not use any electrical appliances inside the cooling unit unless these electrical appliances
are recommended by the manufacturer�
• Do not place the cooling unit near naked flames or other sources of heat (heating, strong
sunlight, gas ovens etc�)�
• Risk of overheating! Always ensure that heat generated during operation can be sufficiently
dissipated� Ensure that the cooling unit is placed at a sufficient distance from walls or objects
so that the air can circulate�
• Ensure that the ventilation openings are not covered�
• Do not fill any liquids or ice into the inner container�
• Never immerse the cooling unit in water�
• Protect the cooling unit and cables from heat and moisture�
DE
GB
19
To Next Page
Loading...
