GB
• Do not open the refrigerator more often than necessary�
• Do not leave the cooler open longer than necessary�
• Use the integrated Eco mode to cool the refrigerator in an energy-saving manner and to
maintain the cooling temperature reached
COOLING UNIT IN USE
ATTENTION! DANGER OF DAMAGE
• Do not switch on the unit immediately after transporting it� This could damage the cooling
system� After transport, leave the unit for at least 30 minutes before switching it on� This will
allow the coolant to collect in the compressor again and the compressor will not run dry�
• Operate the unit on a single power source only� The simultaneous use of the thermoelectric
cooling system and the compressor is not permitted�
• Ensure that only objects or goods that may be cooled or frozen to the selected temperature
are in the cooling unit�
• Ensure that drinks or food in glass containers do not cool down too much� Drinks or liquid
foods expand when they are frozen� This can destroy the glass containers�
• Ensure that the cooling unit is well ventilated so that the heat which is extracted can be
dissipated, otherwise proper operation cannot be guaranteed� In particular, the ventilation
openings must not be covered�
• Place the cooling unit on a firm surface�
Connect cooling unit to 12 V or 24 V
• Protect the line between the cooling unit and the battery with a fuse (maximum 5 A)�
• Connect the 12/24 V connection cable to the cigarette lighter or a 12/24 V socket in the
vehicle�
• The cooling unit starts to cool the interior�
• When you take the cooling unit out of operation:
- Pull out the connector plug�
- Wind the connection cable around the two
• Holder on the back of the unit�
22
To Next Page
Loading...
