EasyManua.ls Logo

Berkel B9-SLC - Page 10

Berkel B9-SLC
54 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 owner/operaTor manUal BK45777 (01-21)
PRODUCTS TO BE USED FOR CLEANING
Onlyusehotwaterandabiodegradabledetergentfordisheswitha7-8PH,atatemperatureofnolower
than30°Cor(86°F)usingasoft,spongyclothandasemi-rigidnylonbrushfortheplateandthe
food press.
ThesanitizerconcentrationshallcomplywithSection4-501.114,ManualandMechanicalWarewashing
Equipment,ChemicalSanitization–Temperature,pH,Concentration,andHardnessoftheFDAFood
Code.BerkelrecommendsusingUSDAapprovedsanitizer,Berkelpartnumber4975-00400.
Ifachemicalsanitizerotherthanchlorine,iodineorquaternaryammoniumisused,itshallbeapplied
in accordance with the EPA-registered label use instructions.
WA R N I NG
Forcleaningthesharpareasoftheplates,thefoodpressandtheblade,werecommendusing
protectivegloves.
Rinse well with a lot of hot clean water and dry with a soft cloth or a spongy material. Do not clean the
slicer with water or stream jets or similar methods.
Cleanalltheremovedpartsusingaclothandacleaningsolution.Rinsewithhotwater.Sanitizeandlet
air dry.
Cleanthesharpenercoverwithwateranddetergent.Carefullycleanthesharpenerassemblyandaround
the stones. DO NOT submerge the sharpener assembly.
CLEANING SHARPENING STONES
CAUTION
Dirty stones cannot sharpen!
Ifthesharpeningstoneshavebecomecoatedwithfoodfats
ormetallicbuild-up,theywillnotsharpeneffectively.
Eachtimethesharpenerisused,thesharpeningstonesshouldbeexaminedforcleanliness.Turnoffthe
slicer,closethegaugeplate,unplugpowercordandopenthesharpenercover.
Ifthereisevidenceoffattyormetallicbuild-upinthestones,theymustbecleaned.Otherwise,they
willnothavetheabrasivequalitynecessarytosharpen.
Clean as follows:
1. Removethenutsandtakethestonesofftheshafts.
2. Soakthestonesinasolutionofdishsoap(i.e.Joy,Dawn,etc.)andwaterforonehour.
3. Scrubthestoneswithastiffbristlebrush(BerkelPart#4975-9237).Rinsethoroughlyatasink.
4. Shakeexcesswateroutandpatpartiallydrywithpapertowelingoracleanclothtowel.Set
aside to air dry.
5. Oncethestonesaredry(after24hours),oiltheshaftswithBerkelFoodMachineOil.
6. Reassemble.
Berkelrecommendsthatasparesetofstones(BerkelPart#825-00112)bekeptavailableforthorough
cleaningprocedures,andincaseofbreakage,soyouwillnotloseyoursharpeningcapabilities.

Related product manuals