To Next PageTo Next Page
Need help?Do you have a question about the Berkel HOME LINE Series and is the answer not in the manual?
The blade is very sharp, like a knife. Pay extra attention to keep hands away from the edge.
Identifies the white start button and the red stop button for machine operation.
Details the machine's identification plate, technical information, and CE marking.
Lists and illustrates key parts like foot, thickness adjustment knob, guards, tables, blade, and cables.
Read instructions, keep away from children, ensure proper training, use as described, maintain concentration.
Do not allow untrained personnel, avoid baggy clothing, keep others away during cutting, maintain machine tags.
Do not remove protections, do not attempt prohibited cuts, keep surfaces clean, avoid using slicer as a resting surface.
Check blade distance, contact service if worn, use correct electrical connections, check power cable.
Install on a level, smooth, dry surface suitable for weight, out of reach of unauthorized personnel.
Install near EEC outlet with protection, differential switch, and earthing system; verify mains agreement.
Pull table back, lift holder, rest product, block with holder, adjust thickness, press start, grip handle for cutting.
Return thickness knob to safety, pull carriage back, press stop button.
Clean daily and if inactive. Use water and biodegradable detergent with soft cloth/brush. Avoid water jets/steam.
Ensure machine is off, lever closed, pull table back, push table upward to tilt clockwise.
Rotate blade cover 90° anticlockwise using knob; a spring facilitates extraction.
Use protective gloves for cleaning sharpening areas, table, holder, and blade.
Clean the blade regularly to keep it sharp and functional. Do not wash in dishwasher.
All repair/replacement activities must be done by authorized personnel. Contact service@berkelinternational.com.
Replace blade when distance between edge and protection exceeds 5 mm.
24 months warranty for defects if used properly. Excludes transport, negligence, improper installation, wear, or voltage issues.
Excludes liability for failure to observe manual, non-conforming use, unauthorized modifications, or non-original parts.
Machine composed of aluminium alloy, stainless steel, electrical parts, motor, and plastic.
Entrust disposal to authorized companies. Proper separate collection facilitates recycling. Deposit at collection point.
Problem: Machine does not start. Cause: No power or defective control circuit. Remedy: Check plug, contact service.
Problem: Machine starts, indicator light off. Cause: Defective indicator light. Remedy: Do not use, contact service.
Problem: Machine does not stop. Cause: Defective control circuit. Remedy: Stop immediately, pull plug, contact service.
Problem: Excessive resistance to movement. Cause: Lubrication not performed. Remedy: Perform periodic lubrication.
Provides dimensions A through L for models 200 and 250.
Lists circular/rectangular cutting capacity, max slice thickness, blade diameter, weight, and motor rating.
General| Blade Diameter | 250 mm |
|---|---|
| Cutting Capacity (Round) | 140 mm |
| Cutting Capacity (Rectangular) | 200 x 140 mm |
| Electrical Specifications | 230 V, 50 Hz |
| Type | Electric Slicer |
