Berkel B9-SLC - Page 11

BK45777 (01-21) owner/operaTor manUal • 11
CLEANING THE RING GUARD
1. Foldaclothwipethathasbeensubmergedinfreshdetergentsolutionandworkitbetweenthe
ringguardandtheknife,startingatthebaseoftheringguard.Carefullyworktheclotharound
theknife,cleaningtheedgeoftheringguardandedgeofthegaugeplate.USE
EXTREME CAUTION.
2. Sanitize and allow to dry.
CLEANING THE BODY OF THE MACHINE
1. Clean the machine body with a damp cloth or a
sponge rinsing frequently with hot water and cleaning
solution. Rinse with hot water. Sanitize and let
air dry.
2. Cleanalsothegaugeplateandtheindexingknob.
While doing this operation pay attention to the knife.
Don’t open the gauge plate or you risk to be cut!
CLEANING THE COMPONENTS IN THE BASE
Thecomponentscontainedinthebasedonotneedanyspecialcleaning;occasionallyremovethedust
that can accumulate in the end area of the carriage and of the thickness plate regulation.
CLEANING THE BLADE
WA R N I NG
Useprotectiveglovesandconcentrateonthejobathand.DANGER!Makesurethicknesscontrol
knobisfullytotheright,sothegaugeplatecoverstheknife.
1. Press a damp cloth on the surface of the blade
andmoveitslowlyfromthecentertotheedge,as
showninthepicture,onthesideofthebladecover
and on the other side.
2. Sanitize and dry in the same way using a dry cloth.
3. Repeat cleaning both front and back of knife with
clear water.
4. Alwaysmovefromthecenteroutward.NEVER
MOVEYOURHANDTOWARDSTHEEDGE
OFTHEKNIFE.Sanitizeandallowtodry.