INTELLIBUS
Number : NR 1157
Revision : B
Page 15/19
Instructions for start-up
INDICATION 1 to 4 IS ACTIVE (option): Indications of hardwired inputs (allows to
communicate through Fieldbus, indications coming from outside devices).
BATTERY LOW OR IS NOT PRESENT: In case of battery option the battery should be
replaced because of too low voltage or the battery is missing.
HANDWHEEL ACTION: the handwheel has been actuated since the last electrical
operation
Function Block DI(5)
Bit n° Value Description
Bit 0 0 The actuator is not running
1 Actuator running
Bit 1 0 No stop mid travel
1 Stop mid travel
Bit 2 0 Power off
1 Power on
Bit 3 0 No lost phase alarm
1 Lost phase
Bit 4 0 No lost signal
1 Lost signal
Bit 5 0 No position sensor power supply fault
1 Position sensor power supply fault
Bit 6 0 No torque sensor power supply fault
1 Torque sensor power supply fault
Bit 7 0 No indication 5
1 indication 5 (*) is active (ESD input by default)
(*)The connection depends of actuator type. Refer to the actuator wiring diagram
ACTUATOR RUNNING: the actuator is operated in opening or closing direction
STOP MID TRAVEL: The actuator is at a stop, neither open nor closed.
POWER ON: The actuator is normally powered.
LOST PHASE: In 3 phase, a phase is missing. No start allowed.
LOST SIGNAL: 4 to 20mA lost signal (In case of analogue and hardwired input signal)
POSITION OR TORQUE POWER SUPPLY FAULT: Intelli+ receives no information from
the position or torque sensor.
INDICATION 5 IS ACTIVE: By default this terminal is assigned to a hardwired emergency
command (ESD) and an ESD command is present.
The actuator feedback position and torque are located at the Function Block Analog Intput
(AI) in the INTELLIBUS module. These indications are:
Function Block AI(1)
Actuator position feedback: 0.0% to 100.0% (1000 points)
ACTUATOR POSITION FEEDBACK: Actuator position in % of opening
0%= closed, 100%= open
Function Block AI(2)
Running torque 0 to 150%
RUNNING TORQUE: Indication of the instantaneous torque. 100% is the maximum
actuator rated torque
To Next Page
