EasyManuals Logo

Berner BI1EGSP User Manual

Berner BI1EGSP
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Page 13 of 44 17.07.2014
Ver. 3.3 © Berner Kochsysteme 2015
Make sure that an eventually used plug is wired correctly:
Start up
Assembly
The induction units are equipped with a main cable which must be connected with a wall
socket or connection box. Electric installations must be carried out by registered installation
companies only, observing the specific national and local regulations. These companies are
responsible for correctly interpreting all regulations and performing the installation in
compliance with the safety instructions.
Indications on warning signs and nameplates must be strictly observed.
Make sure that the main voltage corresponds to
the voltage indicated for the unit (given on the
nameplate).
When installing or installation of this device in
close proximity to a wall, partition walls, kitchen
furniture, decorative panels etc. is recommended
that these are not made of flammable material;
otherwise, they must be covered with suitable
non-combustible, heat insulating material and the
fire safety regulations must be observed most
carefully!
The Induction-Unit has to be build-in with the mounting frame in a flat horizontal area. The
unit have to be build-in and fixed that the unit can`t be moved. The requirements given in
chapter “Installation requirements” have to be fully met.
Remove all parts out of the cooking zone of the unit. Proof if the ceran glass is not cracked or
broken. Stop immediately the start-up if the ceran glass is cracked or broken. Switch off and
disconnect the unit from the main supply.
Turn the controller and main switch in off position before you connect the unit to the main
supply.
For the electric Connection for the Unit take attention.
The Law Regulations of the Country have to be adhered!
Attention
Wrong voltage damage
the Induction unit
Attention
The electrical connection must be only by
specially trained staff.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Berner BI1EGSP and is the answer not in the manual?

Berner BI1EGSP Specifications

General IconGeneral
BrandBerner
ModelBI1EGSP
CategoryHob
LanguageEnglish

Related product manuals