Bernina 900 electronic - Lateral Needle Position Adjustment; Correcting Stitch Distribution

Correct distribution of stitches can
easily head (104) of the adjusting
eccentric. By
be found
by observing the lateral needle
turning slightly to left or right
the lateral
position when the
adjusting screw is tur- needle position
can be set correctly. Re-
ned. In both
side positions the
distance of
tighten screw (103)
after correcting.
the needle
from the edge
of the
The
notch on the
knurled head
(104)
stitch
hole must
be the same.
should be
at the top
Correction
is made
as follows:
IMPORTANT:
Ensure
that there is no
play
Loosen screw (103) slightly. Place
special between swivel support (115) and control
fork
wrench no 39806303 on the knurled
bar (101) when turning the
eccentric.
i _ ~~~lt
95
103
~~~~~~~104
K -
~~~~Fig. 19
7~~~~~~~~~~~~~~~~
-7 -----
L M R
Fig. 19a
115
Fig. 20
13