Bernina 900 electronic - Zigzag Stitch Position; Setting Zigzag Stitch Position

Stitch
position on zigzag.
It this is not the case loosen setscrew
f17)
In order to set the zigzag sttch position
it of the oscillating lever (18) to which the
is necessary for the sideways motion of zigzag link is attached
and move the need-
the needle to be provisionally set
le to the correct position Re-tighten screw
(1-/L
If the zigzag
adjusting knob
l3)1 s sel
to IMPORTANT:
Ensure that
there is no
play
position .4. and the stitch
selector knob between bearing
and oscillating lever when
(14)
is at <
vXa.
(B),
it can
be determined
moving
the oscillating
lever
(18)e
by turning the handwheel whether the left
and right
penetration of the needle are
equidistant from the edge
oM the stitch
hole
Fig 21
17
Fig 22
14