102
· Turn stitch length dial to the desired
length.
· Pattern selector on “ “.
· Center needle position.
· Position the fabric to be darned under
the presser foot together with the
under laying fabric to be used.
· Lower the presser foot and alternately
sew forward or reverse using the
reverse sewing lever.
· Repeat this motion until the area to be
darned is filled with rows of stitching.
For reverse sewing instructions, see page
46.
DarningEN
104
· Turn stitch length dial to the desired
length.
· Pattern selector on “ “.
· Center needle position.
· Fold in the edge of the fabric
(approximately 6 mm 1/4”).
· Place the lace under the folded edge of
the fabric allowing it to underlap the
fabric slightly as required by the
pattern of the lace.
· Sew on the edge of the fabric fold.
· You can add a decorative touch by
using the satin stitch to sew on the
lace.
Attaching lace
EN
To Next Page
Loading...
