106
· Turn stitch length dial to the desired
length.
· Pattern selector dial on “ “.
· Turn zig-zag width dial to small width.
· Cut out the applique design and baste it
to the fabric.
· Sew slowly around the edge of the
design.
· Trim excess material outside the stitching.
Make sure not to cut any stitches.
· Remove the basting thread.
· Tie top and bottom thread under the
applique to avoid unraveling.
AppliqueEN
108
· Turn stitch length dial to the desired
stitch length.
· Pattern selector on “ “
· Center needle position.
· Make sure that the two threads used to
thread the twin needle are of the same
weight. You can use one or two colors.
· Insert the twin needle in the same way as
single needle. Flat side of needle should
face away from you.
· Follow instructions for single needle
threading. Thread each needle separately.
Please note:
When sewing with twin needle, always
proceed slowly, and make sure to maintain
low speed to insure quality stitching.
When using twin needle on zig-zag make
sure the stitch width dial is set between
“0” and “2.5”. Do not use twin needle at
setting above “2.5” . (model 55)
When using twin needle on zig-zag make
sure the stitch width dial is set between
“0” and “4”. Do not use twin needle at
setting above “4” . (model 65/ 80e/90e)
Twin needle
EN
To Next Page
Loading...
