Mastering
Your
BERNINA
®
BERNINA
®
Embroidery Module/Machine
MASTERING YOUR BERNINA
®
EMBROIDERY MODULE/MACHINE 2/06 11
©2006 BERNINA® of America, Inc. Permission to copy granted only to Authorized BERNINA
®
Dealers
Notes
Threading
• Thread machine with the presser foot up (this releases tension)
• Thread using either the horizontal or vertical spool pin with
the foam pad attached
- Horizontal spool pin is for use with cross-wound threads
- match disc size to end of spool
- smallest disc fits into the end of large cones/spools
such as Isacord embroidery thread
- Vertical spool pin is for use with stacked threads
- also for some decorative threads (metallic threads)
- use supplemental thread guide as needed to control
problematic threads
• Use a thread net to prevent thread from forming loops which
might interfere with consistent feeding of thread
• Multiple Spool Holder (optional; available for deco, artista &
aurora)
- attaches to the back of the machine
- holds up to 13 thread spools
Hooping Fabric
• Find the center of the fabric
• Separate the embroidery hoop sections
- Loosen the screw. It should be loose enough that fabric
and stabilizer both will EASILY fit into the hoop
Note: For more information, see appropriate pages in manual
(aurora 430E & 440QEE: pages 67-68; artista 630E/640E
pages 115-116; artista 730E: pages 221-222)
• Embroidery Templates
- Use to ensure that the motif is centered in the hoop
- Each hoop has a corresponding template
- When inserted correctly, “BERNINA” reads left to right,
right side up
- Template surface is marked in 1cm squares
- Each template has cut-outs to facilitate transfer of markings
to fabric
- There are finger holes to facilitate easy removal of the
small and medium hoop templates
- Included with the Large Oval and Mega hoop templates,
special attachment clips facilitate easy removal
To Next Page
Loading...
