Setting up the sewing computer16
Threading the upper thread
•
raise the needle and presser foot
•
turn the power switch to 0
•
place spool on pin and attach the appropriate
spool disc (diameter of spool = disc size)
•
take thread through rear guide A
•
then into slit of upper thread tension
•
pull thread down to the right of the take-up cover to B
•
then up to the left of the cover to C
•
and down through guides D and E
Refer to the safety instruction!
A
C
D
E
C
C
D
E
B
activa 125 (GB) 4.12.2002 14:16 Uhr Seite 16
To Next Page
