V. HOW TO USE YOUR NON-CONTACT INFRARED THERMOMETER
1. Install two batteries according to the manual provided in Section VIII.
2. For the first time use after installing batteries, wait 10~15 minutes for the device to warm
up and adjust to the room temperature.
3. Press the On/Scan button, place 3-5 cm (1.2-2in) away from the forehead (as Fig.1) , aim
the infrared sensor toward the forehead. Make sure the measurement mode is body
temperature mode “BODY” , press the thermometer’s On/Scan button, and the temperature
will be displayed instantly.
Fig.1
4. Before taking an individual’s temperature, make sure that any hair, dirt, or dust is removed
from the forehead and that the forehead is dry. Wait 10 minutes after such removal before
measuring temperature.
For reliable results:
. Do NOT attempt to take an individual’s temperature by aiming the device at a body
part other than the forehead (i.e., arms, legs, torso, etc.) .
. Do NOT move the thermometer before the final result is displayed.
. Do NOT take an individual’s temperature near any drafts (i.e. wind, air conditioner,
To Next Page
Loading...