Bestway 58427 - User Manual

Questions and Answers

J
jesusstevensonAug 3, 2025
Why does my Bestway 58427 not capture debris?
- K
  Karen TorresAug 3, 2025
  There are several reasons why your Bestway Swimming Pool Vacuum might not be picking up debris: * The battery may be low; try charging it again. * The impeller might be jammed. Turn off the vacuum and check the gap in the middle to see if any large debris is blocking the impeller. If needed, contact your dealer. * The impeller could be broken, in which case you should contact your dealer for a replacement. * The filter may be full and needs cleaning.
H
Heather ElliottAug 8, 2025
What to do if debris escapes from the filter of my Bestway 58427 Swimming Pool Vacuum?
- L
  Leah PerryAug 8, 2025
  If debris is escaping from the filter of your Bestway Swimming Pool Vacuum, the suction nozzle flap might be broken. Contact your dealer for a replacement part and instructions.
N
Nicole MorrisAug 13, 2025
What to do if debris goes outside the filter bag of my Bestway Swimming Pool Vacuum?
- C
  Christopher KruegerAug 13, 2025
  If debris is going outside the filter bag of your Bestway Swimming Pool Vacuum, the filter bag is probably damaged. Replace it with a new filter bag.
C
Carol AlvaradoAug 17, 2025
What to do if my Bestway 58427 cannot be charged?
- K
  Krystal MannAug 18, 2025
  If your Bestway Swimming Pool Vacuum isn't charging, it could be due to a few reasons: * The battery might be damaged, and you'll need to contact your dealer for a replacement. * The contact plates of the charger base and unit might not be connected properly. Ensure the charger base is correctly assembled on the unit so that the contact plates are touching. * The external adapter could be out of order. Contact your dealer for a replacement.
J
Joseph MontgomeryAug 22, 2025
How to fix a Bestway 58427 suction head that doesn't move smoothly?
- D
  Darrell ClarkAug 23, 2025
  If the suction head of your Bestway Swimming Pool Vacuum isn't moving smoothly, the ball-wheel might be jammed. Try pushing the ball wheel out of its cavity by inserting a small tool into the hole at the top. Clean the wheel and the cavity, then push the wheel back in.
Z
Zachary TurnerAug 28, 2025
What if the pole connector cannot be secured in assembly of my Bestway Swimming Pool Vacuum?
- S
  Sarah HuberAug 28, 2025
  If the pole connector of your Bestway Swimming Pool Vacuum cannot be secured, the side pin is likely broken. Replace it with a new pole connector.