To Next Page
D
Daniel PerkinsAug 6, 2025
What to do if my Bestway Swimming Pool Vacuum does not capture debris?
- CChristopher GordonAug 7, 2025
If your Bestway Swimming Pool Vacuum isn't picking up debris, here's what you can check: * The debris compartment might be full. If so, clean it and rinse with water. * The pressure relief valve filter could be clogged. Clean this filter and rinse it with water. * The pool suction fitting might be clogged. Clean the pool suction fitting and rinse with water. * The filter cartridge or sand may be too dirty. Stop the pump, block connectors A and B, clean the filter cartridge (or replace it if needed), disconnect the cleaner, and perform a backwash and rinse to clean the sand. * There may be air inside the pump. Stop the filter pump or sand filter, purge the air, and start again. * The wheel may be jammed. Check and remove debris from the wheel.
General
