EasyManua.ls Logo

Beta 1498/12 - Purpose and Safety Guidelines; Product Usage Scope; Work Area Safety Precautions; Battery Handling and Polarity

Beta 1498/12
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
ISTRUZIONI PER L’USO
I
INSTRUCTIONS FOR USE
EN
PORTABLE CAR STARTER, 12V ITEM 1498/12
PORTABLE CAR AND COMMERCIAL VEHICLE STARTER, 12-24V ITEM 1498/24
OPERATING MANUAL AND INSTRUCTIONS FOR PORTABLE STARTER MANUFACTURED BY:
BETA UTENSILI S.P.A. Via A. Volta 18, 20845, Sovico (MB) ITALY
Original documentation drawn up in ITALIAN.
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The portable car and commercial vehicle starter can be used for the following purpose:
Starting cars and commercial vehicles with 12V/24V batteries
The portable car starter must not be used for the following operations:
Use on any batteries other than 12V/24V batteries.
• Use outside the technical specications contained in the TECHNICAL DATA table.
• Use in humid or wet environments, or in bad weather.
• Use for any applications other than stated ones.
WORK AREA SAFETY
Do not operate the starter in environments containing potentially explosive atmospheres,
because sparks may be generated, which can ignite the dust or fumes.
Keep children and bystanders away from your workplace while operating the starter.
Distractions from other people can cause you to lose control over the starter during use.
Do not inhale any harmful gases that may be released by the battery of the vehicle while starting
the engine.
During connection operations, keep your face away from the battery of the vehicle. The battery
contains corrosive substances; in the event of accidental contact of acid with your skin or eyes, rinse
immediately with water and seek medical advice.
Never reverse polarity between the clamps of the device and the battery clips; reversed polarity can
cause explosions or damage to the vehicle, the device and people.
Always connect the output lead with red clamp (+) to the positive post of the battery, and the output
lead with black clamp (-) to the vehicle’s chassis.
Never bring the terminals of the device into direct or indirect contact (e.g. through metal connections).
Do not drop any metal tools on the battery of the vehicle: the battery may short-circuit.
Use the starter in a dry area, avoiding humidity.
IMPORTANT! READ THIS MANUAL CAREFULLY BEFORE USING THE
DEVICE. FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND
OPERATING PROCEDURES MAY RESULT IN SERIOUS INJURY.
CAUTION