Beta RR 4T - 525 - Page 51

18
Workshop manual RR 4T - 250 - 400 - 450 - 525
– Remove clutch drum 1 together with stepped washer 2 and
the two half washers 3 from the driving shaft.
2
1
4
3
– Remove the two needle roller bearings 4 and the support
washer.
Removing the oil pump
– Unscrew the two screws 5 and remove the oil pump cover.
– Remove roller 6, inner rotor 7 and outer rotor 8 from the oil
pump casing.
– Remove oilway screws 9 e 10 with the related seal rings and
then remove the oil line.
3
3
4
6
7
8
9
10