Need help?Do you have a question about the Beta RR 4T-400 and is the answer not in the manual?
General| Brand | Beta |
|---|---|
| Model | RR 4T-400 |
| Category | Motorcycle |
| Language | English |
Explains manual structure, symbols, and operation descriptions.
Defines important terms and symbols used in the workshop manual.
Provides essential safety information for working on the vehicle.
Explains how to identify the vehicle's frame and engine numbers.
Tools for engine mounting, brackets, and chain assembly.
Tools for removing bearings and pulling components.
Special spanners, sealants, and clutch tools.
Engine specifications including displacement, bore, stroke, and other parameters.
Torque values for various engine component fasteners.
Specifications for frame, forks, brakes, wheels, and electrical components.
Schedule for regular maintenance tasks based on time or usage.
Procedures for checking, changing, and maintaining engine oil and filter.
Checking, refilling, and bleeding front and rear brake fluid.
Adjusting front fork and rear shock absorber settings.
How to adjust the engine's idle speed.
Procedures for removing plastic body panels, saddle, and mudguard.
Steps to remove side panels and bumpers.
Procedures for removing front mudguard and fork covers.
Steps to remove the headlight grille.
Steps to remove the engine from the motorcycle frame.
Procedures for disassembling the engine components.
Steps for overhauling and inspecting engine components.
Procedures for reassembling the engine after overhaul.
Steps to install the engine back onto the motorcycle.
Steps to remove and refit the carburettor assembly.
Procedures for disassembling the carburettor components.
Steps for reassembling the carburettor.
How to adjust the engine's idle speed.
Procedure for removing the front wheel assembly.
Procedure for draining the fork oil.
Overhauling fork cartridge and foot valve components.
Steps to reinstall the fork onto the motorcycle.
Procedure to remove the drive chain.
Steps to remove the rear wheel assembly.
Procedure to remove the rear sprocket.
Procedure to remove the swingarm.
Steps to remove the rear shock absorber.
Maintenance procedures for the front brake system.
Maintenance procedures for the rear brake system.
Motorcycle electrical wiring diagrams.
Procedures for battery removal, installation, and charging.
Checking voltage regulators and charging voltage.
Troubleshooting and checking ignition system components.
Checking the main fuse, starting relay, and starter motor.
To Next Page
