7
3 - Tighening torques, specifications, recommended products, Homologation E3 Release 01 Date 09/2007
SPECIFICATIONS - CYCLE PARTS
400/450/525
Frame Single-beam, molybdenum steel frame with double cradle split over exhaust port
Fork “MARZOCCHI” hydraulic upside-down fork (leg Ø 45)
Front/rear suspension travel 290/300 mm
Rear suspension SACHS monoshocks with progressive leverage
Front brake Floating steel disc Ø 255 mm with floating caliper
Rear brake Steel disc Ø 240 mm with floating caliper
Brake discs Wear limit 0.4 mm
Front tyre 90/90 - 21”
Tyre pressure, off road 1,0 bar
Tyre pressure, road use 1,5 bar
Rear tyre 140/80 - 18”
Tyre pressure, off road 1,0 bar
Tyre pressure, road use 1,8 bar
WHEEL DIMENSION (ENDURO) secondary clutch gear 15/45
front cover 90/90-21 54R o 54M
rear cover 140/80-18 70R o 70M or 130/90-18 70R only
Pirelli MT 21 Rallycross Tube Type
front rim 21x1,6
rear rim 18 x2,15
WHEEL DIMENSION (MOTARD) secondary clutch gear 15/43
front cover 120/70-17 58W o 58H
rear cover 150/60-17 66W o 66H
front rim 17x3,5
rear rim 17x4,25
Fuel tank capacity 8,5 litres (including 1 litre reserve)
Chain 135 ZRDK / 007
Bulbs Headlight 12V 25/25W
Parking light 12V 3W
Brake/Rear light 12V 21/5W
Front/rear indicator units LED
Number plate light 12V 5W
Battery 12V 5Ah
Caster angle 26,5°
DIMENSIONS - RR 250
Maximum length 2270 mm
Maximum width 813 mm
Maximum height above ground 1255 mm
Wheelbase 1490 mm
Saddle height 940 mm
Ground clearance 320 mm
Footrest height 405 mm
N.B: Potential tyre change from ENDURO to MOTARD also implies replacing the 15/45 secondary clutch gear with a 15/43
secondary clutch gear (motard Kit option).