24
Workshop manual RR 4T - 400 - 450 - 525
CONVERSION PROCEDURE Km/h - Mph and wheel
selection
In order to convert km/h to mph, proceed as follows:
- Set the instrument panel on the 1st screen, turn off the
vehicle and press the SCROLL pushbutton.
- Start the vehicle keeping the SCROLL pushbutton
pushed until the symbol "Km/h" is displayed.
- "Km/h" and "Mph Miles" will be displayed alternately.
Press the SCROLL key when the intended unit of mea-
surement is displayed.
- After the conversion, and for a short period of time,
the two wheel circumferences available will be shown.
Confirm the value to be saved by pressing the
SCROLL key at the moment it is shown on the display.
ODOMETER ODO FUNCTIONS
The ODO function saves the kilometres travelled
by the vehicle, even with the instrument panel is OFF.
Saving interval: every 2 km
Maximum indication: 99999 km
CLOCK CLK FUNCTIONS
It indicates hours and minutes from 0:00 to 23:59 :59
In order to set the clock, it is necessary to select the
screen 2 and hold down the SCROLL pushbutton for ap-
proximately three seconds. After this time has elapsed,
the desired hour can be selected by pressing the
SCROLL key.
When the pushbutton is released after three seconds,
the instrument panel will automatically shift to the min-
utes. Select the minutes by pressing repeatedly the
SCROLL pushbutton.
TRIP ODOMETER TRIP FUNCTION
It indicates the distance travelled from the last reset-
ting.
Maximum indication: 999.9 km
This parameter can be reset on screen 3 by pushing
and holding down the SCROLL key for approximately 3
seconds.
Remark:
The information from this function is lost when the bat-
tery is disconnected or tension drops below 6V.
STP CHRONOMETER FUNCTION
It indicates a range from 0 to 99:59.99
(Minutes:Seconds.Hundredths of a second)
This counter is controlled by pressing (once the function
is displayed) the SCROLL key for approximately 0.5
second.
1st Push: function activation
2nd Push: counters are stopped
3rd Push: STP reset
4th Push: function activation
5th Push: counters are stopped and so on ....
Remark:
The information from this function is lost when the bat-
tery is disconnected or tension drops below 6V.
To Next Page
Loading...
Need help?
General
