Beta RR 4T-400 User Manual

10
Checking the front brake pads
To check the wear of the front brake pads, visually inspect the
caliper from below. The lining on the visible ends of the two
brake pads should be at least 2 mm thick. Should the lining be
thinner, immediately replace the brake pads.
NOTE: Perform the check at the intervals specified in the Main-
tenance table in Chapter 3.
WARNING: Any delay in the replacement of the brake
pads can result in poor braking and lead to brake disc
damage.
Checking the rear brake pads
To check the wear of the rear brake pads, visually inspect the
caliper from behind. The lining on the visible ends of the two
brake pads should be at least 2 mm thick. Should the lining be
thinner, immediately replace the brake pads.
NOTE: Perform the check at the intervals specified in the Main-
tenance table in Chapter 3.
WARNING: Any delay in the replacement of the brake
pads can result in poor braking and lead to brake disc
damage.
Workshop manual RR 4T - 400 - 450 - 525
04_Inghilterra_059311 27-12-2007 18:10 Pagina 10

Beta RR 4T-400 Specifications

General

Brand	Beta
Model	RR 4T-400
Category	Motorcycle
Language	English