06
8.Joystick Calibration
The joystick data may oset after it has used for a period of time (if joysticks is hit
by physical). User need to re-calibrate joysticks based on following steps:
● After powering on, press SETUP button on the back of remote control radio
transmitter, it hears two "Bee Bee" sounds, and red LED ash quickly (two ashes
each time), which means remote control radio transmitter entered calibration mode.
● Move throttle joystick and direction joystick to middle position, press SETUP
button again, wait until the buzzer beep three "Bee Bee Bee" sounds, red LED light
ashes quickly (two ashes each time), which indicates joystick data has been
acquired and enter into the bounda value calibration mode.
● Slowly rotate the throttle and direction joystick twice around the bounda of the
joysticks(counterclockwise/clockwise), then press SETUP button again, it hears a
long ''Bee'' sound about 3 seconds. And the red LED light stops ashing, indicating
that joystick calibration is complete successfully.
To Next Page
Loading...
Need help?
General