BETAFPV LiteRadio 3 Pro - Radio Transmitter Setting and Binding (ELRS 2.4 G); Internal ELRS Module Configuration; External Module Setup (ELRS)

● Radio Transmitter Setting and Binding (ELRS 2.4G version)
Conrm the built-in protocol: It's ELRS version when the sticker in nano module bay
shows "ExpressLRS".
1. These settings are required when using the internal ELRS TX module, shown as
below.
Set External RF to OFF, and turn Internal RF on and select CRSF protocol.
Binding:󶀅Enter the ExpressLRS.lua inteace, select Bind to do the linking.
Binding: Based on the module manual to do the linking.
2. These settings are required when installing and using the external TX module,
shown as below.
Turn on External RF and select the correct protocol based on the external module,󶀅
set Internal RF to OFF.
External RF
Mode
Ch. Range
Receiver
Trainer
Mode
CH1-16
00
Master/Jack
SETUP 2/11
Mode
CRSF
OFF
05
Internal RF
Mode
Ch. Range
Receiver
External RF
Mode
CH1-16
00
OFF
SETUP 2/11
Glob.Funcs
CRSF
Internal RF
Mode
Ch. Range
Receiver
External RF
Mode
CH1-16
00
OFF
SETUP 2/11
Glob.Funcs
CRSF
BETAFPV 2400TX 0/250 -
>
[Bind]
TX Power
> VTX Administrator
> WiFi Connectivity
[BLE Joystick]
2.2.0 ISM2G4 442a9d