Need help?Do you have a question about the BETAFPV LiteRadio 3 and is the answer not in the manual?
General| Frequency Range | 2.4GHz |
|---|---|
| Screen | No |
| Voice Support | No |
| Support USB Simulator | Yes |
| Firmware Upgrade Method | Via USB |
| RF Power | 100mW |
| Display | No |
| Protocol | Frsky |
| Compatibility | Frsky, Futaba |
| Gimbal Type | Hall sensor gimbals |
| USB Port | USB Type-C |
| Channels | 8 Channels |
| Battery | Built-in 2000mAh 1S Battery |
Turns the radio transmitter off/on with a long press.
Enters binding mode after the radio transmitter is powered on.
Enters joystick calibration mode after the radio transmitter is powered on.
Details long press actions for powering on/off and audible cues.
Explains LED ring states, their reasons, and solutions for transmitter status.
Step-by-step guide to enter binding mode and bind with the receiver.
Internal protocol switching is for CC2500 version; ExpressLRS uses external modules.
Identifies protocols based on LED status (color/flashes) during power on.
Steps to change protocols by holding BIND and powering on.
Red light flashes twice with two beeps indicates low battery.
Turn off, connect via USB, LED breathes red while charging, green when done.
Use as a USB gamepad for simulators for starters.
Connect via USB, install driver, works as HID device.
Detailed steps to recalibrate joysticks to correct offset issues.
Guide to using the configurator for firmware updates and parameter settings.
Device declaration of conformity with FCC Rules Part 15.
Information on radio frequency exposure limits and body-worn operation.
To Next Page
