06
8.Joystick Calibration
● Move throttle joystick and direction joystick to middle position, press SETUP
button again, wait until the buzzer beep three "Bee Bee Bee" sounds, red LED light
s quickly (tw s each time), which indicates joystick data has been
acquir
alue calibration mode.
The joystick data may o
ter it has used for a period of time (if joysticks is hit
by physical). User need to re-calibrate joysticks based on following steps.
● After powering on, press SETUP button on the back of remote control radio
transmitter, it hears two "Bee Bee" sounds, and r
tw s
each time), which means remote control radio transmitter entered calibration mode.
● Toggle the joystick to move to the top, bottom, left, and right joystick boundaries
● Install driver from PC automatically, prompt box pops up after successful
installation. Then, radio transmitter works as joystick
ace device (AKA
HID device) normally.
Operation steps below:
● Connect the transmitter to computer via USB data cable. Wait for the LED ring
breathes in red or green.
● Turn o
adio transmitter.
User needs to manually install driver if PC doesn't install automatically or installed
incorrectly.
DO NOT power on the transmitter and connect it to the PC. The USB is invalid in this
situation.
Other devices
Bluetooth & other devices
BETAFPV JoyStick
Setting up a device
We're setting up 'BETAFPV JoyStick'.
To Next Page
Loading...
